Telemetry

Sensors and actuators using 4...20mA loop are subject to electromagnetic interference (EMI), especially when the wires are long and/or they run close to other wires with noisy signals, such as those going to variable frequency drives (VFD) and alike.  Our data filters greatly reduce such interference while not affecting the core signal.  The filters are completely passive and do not require power.

Data-Filter-Apps-Sensor_edited.jpg

Sometimes it may be beneficial to also consider filtering adjacent noisy wires - we offer special filters for VFD and servo motors - consider them for better results.  You can also try ground filters - often clean ground is a solution for a number of problems.

Relevant Products:

Question on Remote Monitoring?

What is EMI?  A formal definition of Electromagnetic Interference is that it is a malfunction of equipment caused by excessive high-frequency signals, either radiated (via air), or conducted (via wires).  Often it is also called RFI - Radio Frequency Interference.  Most conventionally, EMI is understood as undesirable high-frequency signals, and EMI filters as devices that suppress such signals while preserving the "good" ones.         

 ©2017-2021 OnFILTER, Inc. CleanSweep is a registered trademark of OnFILTER

U.S. Patents 10,263,591; 9,076,806 All specifications are subject to change without notice.

Terms and Conditions of Sale

Tel. +1.831.824.4052  FAX +1.206.360.7458

Our products are made in U.S.A.